Turbo feed Banjo leak

midbugslife · Jan 9, 2015

H all am please looking for some help

I have a pug 307 2002 1.4 hdi. I have changed the turbo about 3 months ago
Where the oil feed pipe goes into the top of the turbo I can not get a seal no matter what I do,
I got 2 copper washers from pug and these apparently goes both sides of the banjo as in one at the top and one at the bottom,

Anyone else had this issue or know how I can fix this

Colin

spanner-uk · Jan 10, 2015

Hi,

What parts were present when you removed the old unit?

Copper washers are the usual choice but have you tried dowty washers?

(Example)

http://workshopsupplies.co.uk/contents/media/l_hsu21.jpg

monty9120 · Jan 10, 2015

on my old 1.6 hdi there was only 1 copper gasket if i remember

Techal · Jan 11, 2015

These oil feed pipes are "free floating". The pipe fits into the banjos with "o" ring seals. When tightening the bolts the banjos have to be central to the pipe. If not then oil will leak past the seals. Hold the banjo central using something like a drill bit or similar ( sorry, can't remember the size ), then tighten the bolt.
Hope this is of some help with your problem.

Turbo feed Banjo leak

Our Vendors

Top Contributors this Month

Recommended Communities