Hello everyone.
So I bought this Chinese Lexia3 cable. it came with 2 dvds one having diagbox and one having Lexia3 and pp2000.
After a lot of sweat I managed to install diagbox in an Oracle VirtualBox VM and managed to activate it and update it.
I also managed to connect the interface , install its drivers and to read its firmware which was 4.3.0 with the interface checker.
So I happily went to connect it to my newly acquired 307 1.6 which has some Antipollution fault... and.... it cant communicate with the vehicle. I tried virtualy everything... with no luck.
I tried running with admin rights... nothing
I tried running with all ignition switch states... nothing
I even tried reinstalling Everything including the vm and diagbox, or pp2000 as stand alone.... nothing....
Although every time I see the interface connecting... and the pp also sees the interface (cause if it doesnt its quiting with a failure message)... I keep getting the message that the ecu hasnt replied.
I even tried to connect to an other 307 2.0 but still nothing
Is my interface not working? how can I test this?
The only thing I havent tried and I would if I could is to install win xp on my laptop... which I actually did... but I couldnt find the drivers for any of the laptops devices so I scraped that...
Any help would be appriciated.
Thank you very much.
So I bought this Chinese Lexia3 cable. it came with 2 dvds one having diagbox and one having Lexia3 and pp2000.
After a lot of sweat I managed to install diagbox in an Oracle VirtualBox VM and managed to activate it and update it.
I also managed to connect the interface , install its drivers and to read its firmware which was 4.3.0 with the interface checker.
So I happily went to connect it to my newly acquired 307 1.6 which has some Antipollution fault... and.... it cant communicate with the vehicle. I tried virtualy everything... with no luck.
I tried running with admin rights... nothing
I tried running with all ignition switch states... nothing
I even tried reinstalling Everything including the vm and diagbox, or pp2000 as stand alone.... nothing....
Although every time I see the interface connecting... and the pp also sees the interface (cause if it doesnt its quiting with a failure message)... I keep getting the message that the ecu hasnt replied.
I even tried to connect to an other 307 2.0 but still nothing
Is my interface not working? how can I test this?
The only thing I havent tried and I would if I could is to install win xp on my laptop... which I actually did... but I couldnt find the drivers for any of the laptops devices so I scraped that...
Any help would be appriciated.
Thank you very much.
