Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
345 Posts
Discussion Starter #1
Yesterday the fuel pipe popped off and caused the car to cut out and has put up an anti pollution fault.

I connected it back up and the car started after priming the bulb.

Today the engine management light is still on and I'm still getting the pollution fault, but now it's disabled the passenger air bag??

Any advice would be greatly appreciated.

Many thanks
Ben.
 

·
Moderator
Joined
·
5,669 Posts
Just try driving it for a few days, if light was tripped by low fuel pressure from pipe etc then light should go out after 3-5 journeys where the fault does not re occur as ecu will reset it and log it as a historic fault
 

·
Registered
Joined
·
345 Posts
Discussion Starter #7
Well this is still happening?!?

We plugged it into a friends pp, but apparently no codes have been stored...

Would a bsi reset clear the eml light?
 

·
Registered
Joined
·
345 Posts
Discussion Starter #8 (Edited)
A kind member plugged it in to his pp today.

Here are the results.


We cleared the codes as there are no running issues, so I'm guessing the fuel code is ok now?

Just wondering if anyone has any opinions on the other faults?
 
1 - 8 of 8 Posts
Top