Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hi,

My drive shaft broke and I have replaced it. Unfortunatly the new shaft has only 29 teeth on the ABS ring whilst the other side has 48.

Can this be adjusted in the cars software? Is there a quick solution?

/Klabert
 

·
Moderator
Joined
·
6,289 Posts
No way to change in software but you may be able to swap the ring or outer joint between drive shafts
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Thanks for helping. I was hoping for a easy fix but didnt really beleew in it. I just need to get under there again. I dont have a tourch to heat a new ring so I guess I´ll have to replace the other sides shaft.

Best regards,
Klabert
 

·
Moderator
Joined
·
6,289 Posts
You will need to replace the shaft you have fitted if you change other to match you will have problems with front/rear readings, front will be half speed of the rears due to the lower number of teeth and this will also trigger fault
 
1 - 5 of 5 Posts
Top