I was hoping not to have to ask, but I'm having no luck searching.
Can anyone tell me where I can find the circuit diagrams for a 62 plate Boxer please? It's an AutoSleeper motor home on the boxer chassis and the air con isn't working. I've had it re-gassed and all ok. The garage said there wasn't any power getting to the compressor, so they weren't sure what the issue might be. They were fully booked and so couldn't spend much time after my re-gas. I've checked the fuses and, with a lot of searching, found which relay is for the air con. I've tested it and it's working fine and I'm getting 12v to the relay coil terminals, so it's turning in to a puzzle. I need to get underneath and check the supply to the compressor to confirm the garage's findings. However, we've been getting monsoon rains today, so haven't managed to do that yet. Was hoping to find a circuit diagram, to see if anything else might be influencing things. Am I right in thinking that if there's 12v to the relay and the relay is working ok, the relay should be feeding 12v directly to the compressor without any other sensors stopping it?
Many thanks, Al
Can anyone tell me where I can find the circuit diagrams for a 62 plate Boxer please? It's an AutoSleeper motor home on the boxer chassis and the air con isn't working. I've had it re-gassed and all ok. The garage said there wasn't any power getting to the compressor, so they weren't sure what the issue might be. They were fully booked and so couldn't spend much time after my re-gas. I've checked the fuses and, with a lot of searching, found which relay is for the air con. I've tested it and it's working fine and I'm getting 12v to the relay coil terminals, so it's turning in to a puzzle. I need to get underneath and check the supply to the compressor to confirm the garage's findings. However, we've been getting monsoon rains today, so haven't managed to do that yet. Was hoping to find a circuit diagram, to see if anything else might be influencing things. Am I right in thinking that if there's 12v to the relay and the relay is working ok, the relay should be feeding 12v directly to the compressor without any other sensors stopping it?
Many thanks, Al
