Peugeot Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi all,

Sorry to bring up such a well covered topic, but I'm having a bit of difficulty that I haven't seen mentioned on here so far. I have a 2008 (58) 2L diesel 407 and I've been trying to turn off the tyre pressure monitor system using Diagbox v6 installed on windows 7. I know it's supposed to be installed on XP, but it does appear to be working OK.

My problem is, that when I'm trying to set the under inflation ecu to absent in the BSI, the only options are 'present' or 'missing'. Also, when trying to turn off the under inflation in the MFD, it comes up as a non-configurable parameter.

Can anyone help with where I'm going wrong? Is Diagbox 6 compatible with my car/ecu? Would I be better using pp2000 on an XP laptop, or would it be the same?

I was looking forward to getting rid of that beep!

Kind regards,
Craig
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
Yes. Earlier this afternoon, but I have also driven the car once today, for a few miles.

Any ideas on why the only options are 'missing' or 'present' instead of 'absent' in the BSI ECU list?

Thanks for you help.
 

·
Registered
Joined
·
1,949 Posts
"missing" is the correct parameter on Diagbox, it worked ok on my 3008.
 
1 - 8 of 8 Posts
Top