Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi,

So have had the TPMS valves shred on my two front wheels, happened on the rear a few months ago and i changed the valves with the kit from ebay, all fine. i come to do the same with the front and when getting the valve out the little metal strip comes off of the sensor...

1. Anyone know what this does, and is it needed for the sensor to work?
2. Could i just "solder" it back on? i have a fine tip iron and not bad with electrics :)

Finally i hear a bit of talk around Jag/Ford TPMS. does anyone know for sure if the whole sensor can be swapped(assuming i get it recoded). So replace the full 407 TPMS sensor with a Jag/For sensor, after all they all run on 433Mhz frequency?
 
1 - 1 of 1 Posts
Top