Peugeot Forums banner
1 - 1 of 1 Posts

· Registered
62 Posts
Discussion Starter · #1 ·
Ok I thought I'd post this may be of help this is the procedure for
2009 peugeot 207cc 1.6 vti 120bhp. I write down instructions direct from pp2000

Leave the ignition 2,5 without touching the accelerator with the engine switched off (throttle learning)

The ecu must be in main triggering mode: press the accelerator pedal down fully for 5 seconds, return to the "pedal released" position then start the engine without accelerating (pedal sensor programming)

A powerlatch phase is required (at any point in the process),without disconnecting the battery for the programming procedure to be memorized completely.

Hopes this helps
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.