Peugeot Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
1,860 Posts
Discussion Starter #2
Sorry used phone to load image text never went up weird

This is my throttle body mount you will see that plastic is attached the body mount holes are not formed correctly and would allow air to pass is this an issue, I am assuming that the mount and body should separate as mine is lol

Thanks

Allan


Sent from AutoGuide.com App
 

·
Registered
Joined
·
1,860 Posts
Discussion Starter #7
Hi David thanks for clarifying the part name

When I have looked at the bottom of the unit where it sits on three pins it at some point must have been hot. The plastic that fits the three male clips are holes, I am unsure if it should be sealed as I can see nuts when I look in the holes.

It just seems odd that the pipes use clips in yet air can get in the bottom

Thanks agin

Allan



Sent from AutoGuide.com App
 

·
Registered
Joined
·
1,860 Posts
Discussion Starter #9
That may easy be the case I have located a used one on eBay but its 450 miles away so can not see it however it does not have a mount with it it's £80 so did not want to buy it unless the air getting in the holes would cause problems

Thanks again


Sent from AutoGuide.com App
 
1 - 11 of 11 Posts
Top