Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
just brout the wife a 206 51 reg 1.1

now previous owner as fitted some racing steering wheel and so airbag light flashes all the time

now missis wants an original one fitting back on (looking for one anyone have 1?)

just wondering are they easy to change back on these??


cheers guys
 

·
Registered
Joined
·
862 Posts
evompv_andy said:
just brout the wife a 206 51 reg 1.1

now previous owner as fitted some racing steering wheel and so airbag light flashes all the time

now missis wants an original one fitting back on (looking for one anyone have 1?)

just wondering are they easy to change back on these??


cheers guys

Is there an airbag fitted to the current steering wheel?
 

·
Registered
Joined
·
862 Posts
This is a pretty straight forward job

1. Disconnect negative battery terminal.
2. Center steering wheel in straight-ahead position
3. Remove hex nut in center of steering wheel
4. Remove trim below steering column switch. (You will find 2 phillips head
screws on at the bottom, on either side of the steering column, of the trim
piece) Disconnect wiring harness connector (remove foam sleeve from
connector if fitted). (Follow the wire coming out of the airbag to the
harness connector.)
5.Place new wheel on to hub and tighten the T50 Hex drive bolt.This is what holds the wheel on so make sure its tight (possibly a 21mm bolt)
6.Place the air bag unit into the space for it.Re-fit and tighten both socket head screws from rear of steering wheel (airbag unit
mount screws).you will need to turn the wheel for this.
7.Re-connect wiring harness and replace all trim removed.

7.Re-fit trim to the steering coulmn re-connect battery check everything works horn etc.
 

·
Registered
Joined
·
39 Posts
the moose said:
This is a pretty straight forward job

1. Disconnect negative battery terminal.
2. Center steering wheel in straight-ahead position
3. Remove hex nut in center of steering wheel
4. Remove trim below steering column switch. (You will find 2 phillips head
screws on at the bottom, on either side of the steering column, of the trim
piece) Disconnect wiring harness connector (remove foam sleeve from
connector if fitted). (Follow the wire coming out of the airbag to the
harness connector.)
5.Place new wheel on to hub and tighten the T50 Hex drive bolt.This is what holds the wheel on so make sure its tight (possibly a 21mm bolt)
6.Place the air bag unit into the space for it.Re-fit and tighten both socket head screws from rear of steering wheel (airbag unit
mount screws).you will need to turn the wheel for this.
7.Re-connect wiring harness and replace all trim removed.

7.Re-fit trim to the steering coulmn re-connect battery check everything works horn etc.
good to know
thnx
 
1 - 5 of 5 Posts
Top