Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1 (Edited)
I have weird issues with my 2.0 hdi 136bhp. The car starts and runs fine when it is cold. Car and the outside temperature. But when hot, engine or outside temperature, car starts up and shuts down after few seconds. Water in fuel error appears every time it shuts down, but I have no sensor and it has been disabled in PP2000. After few starting attempts, car is impossible to start. Few hours later, when it gets cold, starts and runs fine.
PP2000 says Engine ecu, permament fault, disel pressure regulator signal coherence, Engine ecu permanent fault, injection ecu internal fault. Diagbox says U1108 and U2000. New software has been downloaded, enfine ECU has been replaced, underbonnet fuse box has been changed. Any ideas?
Forgot to mention, I have faulty fuel temperature sensor.
Can someone check me by the VIn number what was originaly fitted in the car?
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Fuel sender? Is that black box with Magnetti Marreli writing on it? It has been disconected, I have removed DPF.
 
1 - 3 of 3 Posts
Top