Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
687 Posts
Discussion Starter #1
As a few you know, I managed to get an new navi head unit working in a car originally fitted with a RT3 unit and get the dash display and stalk working after replacing the fascia loom.

However, I never connected up the speed pulse or the reversing connections. Can I take these directly from the CAN system that runs into the BSI? I bought a connect2 CAN reader to play with when I was trying to figure out the installation of the navi unit. If not the CAN bus, where else would be the best place to get the speed pulse and reversing input from? Can I assume that the reversing switch is one of the connections by the gear stick or is it on the gear box?

I lost the signal going through some tunnels and around some large buildings in Brussels and would love to improve the accuracy when the signal is not great and maybe fit a reversing camera at some point:nod:
 
1 - 1 of 1 Posts
Top