Peugeot Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Hello,
I bought a P407 2.0 HDi from the year 2005 recently and it has a common problem - a bad MFD. I found and purchased a new color MFD (the small one with 12-pin connector) for P407 on eBay and asked a guy from the Czech Peugeot forum to configure it, but we did not succeeded. The display is accesible through both Planet and Diagbox softwares, it is possible to change the language of the display and to test the screen but every attempt for saving the user functions configuration (radio, parking assistant, etc.) ends up with an error in remote communication. I am not sure whether the problem is in compatibility (the car is from 2005 and the display from 2008) or in some "hidden trick" in the diagnostic software because we tried almost everething including disconnecting cars battery. The radio in the car is the RD4 without MP3 playback.
Would anybody be so kind to give me some advice, please? Thank you very much.

P.S. The MFD type is JCE-EMF C-C1M CEM1, SW 61.0
 

·
Registered
Joined
·
33 Posts
Hello,
I bought a P407 2.0 HDi from the year 2005 recently and it has a common problem - a bad MFD. I found and purchased a new color MFD (the small one with 12-pin connector) for P407 on eBay and asked a guy from the Czech Peugeot forum to configure it, but we did not succeeded. The display is accesible through both Planet and Diagbox softwares, it is possible to change the language of the display and to test the screen but every attempt for saving the user functions configuration (radio, parking assistant, etc.) ends up with an error in remote communication. I am not sure whether the problem is in compatibility (the car is from 2005 and the display from 2008) or in some "hidden trick" in the diagnostic software because we tried almost everething including disconnecting cars battery. The radio in the car is the RD4 without MP3 playback.
Would anybody be so kind to give me some advice, please? Thank you very much.

P.S. The MFD type is JCE-EMF C-C1M CEM1, SW 61.0
Hi mate where you buy this display ?? i need same displayw ith high SW to work with continetal bluettoth module

Regards
Lucas
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Hello,
I have got the display through german E-bay, but I would not recommend it. It is not possible to configure it by "chinese" tools, finally, member Ultramate from this forum was able to partially configure it (many thanks again), but the display is still not capable to show digital air-con, so I have no clue about the temperature settings nor the vent direction. Since I have not any handsfree module I dont know whether it supports it or not. I plan to sell the display, but perhaps to somebody in Czech rep. because there might be problems with configuration and sending a display back and forth across the Europe is rather expensive.
 

·
Registered
Joined
·
33 Posts
i can buy from you this display if you want sell :) or we can swap for display from 2012 (black/orange) full configured by me i also have pp2000 and lexia tool
(air con, bluetooth, parking sensors everything on)


Regards
Lucas
 
C

·
Guest
Joined
·
0 Posts
Lucas

How much would you want for the display if Ondon does not want it mine is an orange one and fades when warm.
 

·
Registered
Joined
·
33 Posts
Lucas

How much would you want for the display if Ondon does not want it mine is an orange one and fades when warm.
one i have on ebay right now for 130, display is from citroen ds3 2011 year
i sell right now one from citroen c5 thats be cheaper :) only is already sold :)

Regards
 
D

·
Guest
Joined
·
0 Posts
Hello,
I have got the display through german E-bay, but I would not recommend it. It is not possible to configure it by "chinese" tools, finally, member Ultramate from this forum was able to partially configure it (many thanks again), but the display is still not capable to show digital air-con, so I have no clue about the temperature settings nor the vent direction. Since I have not any handsfree module I dont know whether it supports it or not. I plan to sell the display, but perhaps to somebody in Czech rep. because there might be problems with configuration and sending a display back and forth across the Europe is rather expensive.
Configure it using Citroen c5. Its a software issue.

Sent from AutoGuide.com Free App
 
C

·
Guest
Joined
·
0 Posts
one i have on ebay right now for 130, display is from citroen ds3 2011 year
i sell right now one from citroen c5 thats be cheaper :) only is already sold :)

Regards
Ok Cool I take it they are compatible with my 2005 407 then
 

·
Registered
Joined
·
33 Posts
Hello,
I have got the display through german E-bay, but I would not recommend it. It is not possible to configure it by "chinese" tools, finally, member Ultramate from this forum was able to partially configure it (many thanks again), but the display is still not capable to show digital air-con, so I have no clue about the temperature settings nor the vent direction. Since I have not any handsfree module I dont know whether it supports it or not. I plan to sell the display, but perhaps to somebody in Czech rep. because there might be problems with configuration and sending a display back and forth across the Europe is rather expensive.
hi mate still you want sell this colour display ??

Regards
 

·
Registered
Joined
·
54 Posts
hi mate still you want sell this colour display ??

Regards
Blackangel

I have recently bought a 407, and the seller put a new display in, but it only shows passenger climate control, not driver side.
I guess this can be fixed by configuring?
Is it possible for you to reconfigure it? If you can, can I post it to you to sort out, and how much would you charge?
 
1 - 13 of 13 Posts
Top