Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi,

I changed the rear discs yesterday on my 307 and the things just slid right on there no problem. Then I tried to spin the discs around and all was fine, then they stopped moving. The rubber rings have been chewed up a fair bit.

Is this rubber ring part of the ABS ring or is it just protection for it? If not is it possible just to change the ABS ring and not have to waste 2 new discs :(

Next question is are the ABS sensors adjustable to allow for the extra clearance.

Any help would be really really appreciated.

Thanks!
 

·
Registered
Joined
·
5,904 Posts
The abs sensor has probly been pushed closer to the ring due to corrosion on the back plate. Would be advisable to remove the sensor and clean any rust away before fitting it all back together again.
 
1 - 4 of 4 Posts
Top