Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
hello i have a 1999 partner with kfx engine and as you know it has no tachometer on gauges. i have installed one but i dont know where to get the signal from.
 

·
Registered
Joined
·
696 Posts
best diagrams i could find

screen-shot-12-19-17-at-07-26-.jpg

screen-shot-12-19-17-at-07-26-(1).jpg

screen-shot-12-19-17-at-07-27-.jpg


looks to me like the rev counter is using wire 480 on connection number 9 on the ECU coming from connection 7 on the dash .. which looks like it connects into wire 4800 on the diagnostic plug on the 3rd diagram,hard to see what connection it uses but you should be able to find numbers if you check the wires

not sure if wire 426 from connection 1 on the dash is used or not it looks like it goes to connection 42 on the ECU and again seems to be spliced into the diagnostic connector
if you check the ECU you may find numbers to tell you what pin is what ,,you may have to unplug the plug/plugs from the ECU to see them..

failing that if you can post what model of ECU your van has i may be able to source a pinout diagram

Terry
 
1 - 2 of 2 Posts
Top