Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter #1 (Edited)
Hello dear friends,
I've turbocharged my Peugeot 307 1.6 TU5JP4 engine and installed a plug and play ECU on it, unfortunately the RPM on the cluster is not working so I mounted an aftermarket Autometer tachometer like this one

Basic Tach Installation: http://youtu.be/omxgOH-JngI

Please someone can tell me where is the signal pin/wire on the diagnostic connector or ECU?

Thank you very much in advance
 

Attachments

·
Moderator
Joined
·
5,630 Posts
There is no suitable signal available which will power this type of tacho as the car has a coil pack for ignition. You would need some kind of adaptor interface or an electronic unit which can get engine data via obdc

The last unit on this page may work or google coilpack rev counter diodes

http://trigger-wheels.com/store/contents/en-uk/d36.html
 

·
Registered
Joined
·
63 Posts
Discussion Starter #3
There is no suitable signal available which will power this type of tacho as the car has a coil pack for ignition. You would need some kind of adaptor interface or an electronic unit which can get engine data via obdc
Thanks for replying, actually I can see the RPM through the ECU and software which came with the turbo kit, but it's not working on the dash! And when i plug the stock ECU the rpm on the cluster works! That's the reason why I hooked up an aftermarket tacometer and was planning to take the signal From the ignition output
 
1 - 3 of 3 Posts
Top