Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
I have replaced the rear Park Assist ECU, since it drowned when the spare Wheel bay got flooded.
Now, I cant get it to the display.
I cant find any settings in Diagbox to route the information to the MFD.
ANyone that has any Idea how to do it?
Using Diagbox 7.64 and the car is a 407-2004 sedan with 2.2 litre petrol.
 

·
Moderator
Joined
·
6,079 Posts
You may need to check the ECU configuration some ecu's require vin coding for full CAN functionally to work correctly

Sent from my SM-G935F using Tapatalk
 

·
Registered
Joined
·
9 Posts
I fitted a new display in my 407 last week from an 807 and had to make the climate control visable on the display. ..I also seen the option to make the reverse sensor visible using diagbox.
Cheers Phil
 

·
Registered
Joined
·
24 Posts
Discussion Starter #5
I have tried all things I can find, in the display, Parkassist enabled.
In the BSI, Park assist Enable, and in the Park assist ECU, the same thing, but disabled the buzzer.
 

·
Registered
Joined
·
9 Posts
Sorry..I can't help you any further at the moment
My 407sw is missing the module and I can only find the wiring to the sensors.. the wiring to the bsi seem to be missing.
I have an 807 I can get access to at some point and check on that.. I've only had diagbox for a few days and am still finding my way around
Cheers Phil
 
1 - 6 of 6 Posts
Top