Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
I have got a replacement regulator for my left back door window. Old engine is out, the window has been disconnected but I can't figure out how remove the vertical part of the regulator. Says here earlier in the tread, that it's held in place by two rivets. But I can't locate them. Where are they? I guess I have to drill them out, but then I'll have to be pretty accurate. Btw, it's a 2005 407SW.

(introduction would have been good...but hi anyway!)
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Thanks! I thought I had removed everything, but there were actually some small pieces left at the exact wrong places. :( So now it's out and buy a pivot gun tomorrow. Another thing working again. (Just had to change all of the brake system, servo, lock on the rear door, ABS and a few moving parts in the engine. Other than that it's quite reliable). Again. Thanks a lot. :)
 
1 - 3 of 3 Posts
Top