Peugeot Forums banner

1 - 6 of 6 Posts
J

·
Guest
Joined
·
0 Posts
How do you mean what type?? I take it which brand do people recommend, as there is only going to be one brake pad that fits :thumb:
 

·
Registered
Joined
·
30 Posts
Discussion Starter #4
rear pads .407

many thanks to the replies to my question !!!!!:eek:
I was told by a person that there was 2 types of pad for my car.
but thanks to u i have now got hold of the correct pads , but now i have another problem .
i went to change my pads and was getting on fine until i found out i did not have the correct tool for the job .
i didnt know there was such a thing has a piston caliper wind back tool.i have just finished putting it all back together and will try again on monday when shops r open to buy this tool !

once again thanks to you that replied
 
J

·
Guest
Joined
·
0 Posts
May not be the right way to do it, but whenever I changed them on my 306, I used to just use a small piece of square bar (5mm²).... being careful not to damage the rubber seal around this always did the job :thumb:
 
1 - 6 of 6 Posts
Top