Peugeot Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi my 1.5d 106 has a leaky brake cylinder on the back drum brake and when i went to replace it I discovered the nut had been rounded on the copper brake line.
Im in a situation now where im gunna have to cut it off with an angle grinder in order to replace it.
I was wondering if I could replace the copper brake line with a braided hose instead and whether this would be compatible with the brake cylinder?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.