Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
I need to change the discs so but the callipers are held on with torx bolts which have been done up very tightly, I have used to T50 bits on the so far anyone got any ideas how to get these bolts undone?

Thank you
 

·
Registered
Joined
·
548 Posts
I need to change the discs so but the callipers are held on with torx bolts which have been done up very tightly, I have used to T50 bits on the so far anyone got any ideas how to get these bolts undone?

Thank you

A good quality & fitting torx bit (preferably impact), not the ones made of cheese, a decent ratchet or as long bar as you can fit in the space.

Its not an easy bit to try and use heat to help remove but a good does of wd40/plusgas the night before should help.

Often a tap with a rubber mallet on your bar can 'shock' them free if you are struggling.
 
1 - 3 of 3 Posts
Top