Peugeot Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello guys, last year I installed the original alarm on my Mux Peugeot 206 (9671.8L) and this year I made the decision to retrofit the original rain sensor.
First I noticed that my car did not had the extra wiring needed pre-installed from the factory. So I had to make it. I followed carefully the following graph from my SEDRE program

1.jpg

Everything was done and the rain sensor is mounted on my windshield.
However here comes the PROBLEM.
I enabled the rain sensor, and luminosity sensor through PP2000 and when I run a Global Test when it comes to rain sensor it says: " THE ECU HAS NOT REPLIED". Somehow the sytem cannot see the presence of the sensor.
Guys do you know what that means? Do you know how to fix it? I really need your advice.

Many thanks in advance
Regards, Panos
 

Attachments

·
Moderator
Joined
·
8,878 Posts
Did you fit fuse 14 which is power to the unit. If it still does not work check in servicebox BSI/Fuse box numbers as it be the BSI hardware does not support it
 
1 - 3 of 3 Posts
Top