Peugeot Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
Hi all

Just after some advice on faults codes after a visit to janner

P0472 permanent fault differential exhaust pressure signal
P1457 particulate emission filter pierced or absent

P0470 differential exhaust pressure signal

P1351 intermittent fault pre heating relay circuit. Relay controlled and spark not supplied

Parking aid
Abc9 and fbc9 both say interior right sensor fault

Airbag ecu E607

Front left side air bag high stop local " diagbox advises ignition module "

F000 fault engine wiring house ecu mute on can "diagbox advises engine fuse box not com on can"

Power steering C1210 fault engine running

I'm sure there are some clever people who have answers for these
The airbag is critical for the mot due in one month

Thanks in advance
 

·
Registered
Joined
·
5,904 Posts
1351 - ignore. Every car I've diagnosed has that error showing. Seems to be a false error due to using clone equipment. One menber had that show on his car with his own diagnosttic kit but the next day when the car was on a dealer diagnostic it didn't appear.

The differential pressure errors read as if the DPF has been physically removed but not removed from the list of ECU's or mapped out of the ECU. Could also be a bad sensor or possibly a ruptered filter cannister.

The description I get for C1210 is - ABS Outlet valve coil RF circuit failure

Parking aid sensor fault description appears to be pointing to the inboard sensor on the right of the car.

E607, F0000, Abc9 & Fbc9 - No information are these real codes ?

Are these codes from Diagbox, PP2000 or some other diagnostic kit
 

·
Registered
Joined
·
28 Posts
Discussion Starter #3
1351 - ignore. Every car I've diagnosed has that error showing. Seems to be a false error due to using clone equipment. One menber had that show on his car with his own diagnosttic kit but the next day when the car was on a dealer diagnostic it didn't appear.

The differential pressure errors read as if the DPF has been physically removed but not removed from the list of ECU's or mapped out of the ECU. Could also be a bad sensor or possibly a ruptered filter cannister.

The description I get for C1210 is - ABS Outlet valve coil RF circuit failure

Parking aid sensor fault description appears to be pointing to the inboard sensor on the right of the car.

E607, F0000, Abc9 & Fbc9 - No information are these real codes ?

Are these codes from Diagbox, PP2000 or some other diagnostic kit


Thank for the reply

All codes were generated this morning when I visited janner
I'm sure the codes are from either planet 2000 or diagbox one needed windows xp the other windows 7
 

·
Registered
Joined
·
28 Posts
Discussion Starter #6
Janner emailed the full report from diagbox

This is the part about the airbag

AIRBAG : Air bags and pre-tensioners control unit
Response data
R61809646864780000E96544912800605FF01024046595399

State of the ECU: SAC_AUTOLIV
Reference 1 : 9654491280
Reference 2 : 
Faults present : 1
E607 : front left side air bag ignition module fault
Characterisation : Resistance too high
Status : 
Location : local
Variables associated with the fault
 
1 - 7 of 7 Posts
Top