Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter #1
Can anyone help me with this, iv finally got into my 307 and reset the bsi so i can now lock and unlock the car after. im trying to run a diagnostic on it to try cure my abs/esp issue but i fear my planet wont work because it is a b rev cable and not the c

When i try to scan my 307 it comes up with the message 'the ecu has not replied'
 

·
Registered
Joined
·
71 Posts
Discussion Starter #2
ayone help out, ive read people say a rev b cable will work on an older version of the sofware? should i look for a older version of the lexia software instead?

my 307 is the 2002 model not the facelifted model
 

·
Moderator
Joined
·
5,631 Posts
/B will work with all versions of Planet only later versions of diagbox needs /C (Peugeot added code to software to try to defeat clones).

I have never had a 307 that would not work with my /B interface
 

·
Registered
Joined
·
96 Posts
When i try to scan my 307 it comes up with the message 'the ecu has not replied'
Maybe its telling the truth.. :D

Looking back at your previous posts, I'd hazard a guess that either the software has not been installed correctly, or the laptop usb ports have not configured.

Control panel / System / Hardware / Device Manager

A device list is displayed, in which you can find: ACTIA USB Device

If you click on it, a new line appears: USB Com Board Driver

Or C: Theres no power getting to the interface from the usb port

Or D: Its broke, lol

:confused:
 
1 - 6 of 6 Posts
Top