Peugeot Forums banner
1 - 3 of 3 Posts

2 Posts
Discussion Starter · #1 ·
I recently bought a 308, 1.4, 2008, after about 2 weeks I got anti pollution fault come up and car started to drive lumpy, then engine management light came on, radiator cooling fan was on full all the time and over ran for about 5 mins,I had fault code p1034 come up,
I changed cooling fan resistor, fan still on full but cuts out after about 2 mins after engine is switched off, I also replaced cam sensor, fan relay and checked all connections
Stumped now, what else can I check????
All fluids are ok and caps on tight
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.