Peugeot Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Can anyone help cars a 57 reg I have replaced head gasket due to oil leak reassembled the engine using correct sealant for dohc covers with new cam shaft seals also but i now have a bad oil leak at the seal ends I'm wondering if i have applied the sealant in the correct place at the cam shaft seal ends of the bearing plate? there is a machined groove that could allow oil right up to the plastic seals should that be filled with sealant ? the haynes manual diagram shows the bead of silicone just short i didn't want to fill the groove incase its an oil passage any advise from the pros would be great please
 
1 - 1 of 1 Posts
Top