Peugeot Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter #1
Hi Guy's..

I have an 06 citroen berlingo and sent it in for a vallet the other day.

since then, ive had no dash lights and it wont start (turns over ok)

it does say eco-mod on the dash.

I'm assuming that the lad who valleted it had all the doors open whilst cleaning it and thats the reason for the eco mode.

I have tried another BSI off another berlingo and all the dash lights work but wont start (didnt think it would because of the imobaliser).

Can anyone help me to try & resolve this??

Many thanks in advance.

ASH
 

·
Registered
Joined
·
5,904 Posts
BSI off another car wouldn't work as it has to be matched with the ECU and the key will not be programmed to it to unlock the immobiliser. I'm presuming it ran after the Valet to get it back home so it's a bit of a puzz;er if that's the case. If it hasn't run since the valet then I'd be inclined to get the valeter to sort it out, after all it was running fine when it was left for them.

Leaving the doors open with the light drawing power would lead to economy mode as they are programmed to turn off all non essential electrical items after a set time to preserve battery power. If the car hasn't run since the valet then there is a possibility that the BSI has lost the key transponder code. If it has run then the code is still programmed into the BSI to allow it to start. With the key in the ignition does the car beep when opening the drivers door? If it doesn't it is likely to need the keys reprogramming.
 

·
Moderator
Joined
·
11,838 Posts
Economy Mode would only disable accessories like heaters and radio, it wouldn't disable something as important as dashboard lights.

Take it for a good run in daylight to charge back up, or put the battery on charge, ensuring you do a BSI reset. If that doesn't work, get a diagnostic check. That will tell you why its not firing.

To be honest I'd be looking more towards the competency of the valeter if its only happened since they had it. They didn't pressure wash the engine bay did they?


http://www.peugeotforums.com/forums/general-discussion-2/how-contact-member-peugeot-planet-diagnostic-28190/

http://www.peugeotforums.com/forums/introductions-28/brief-faq-guide-new-members-83170/#post529130
 

·
Registered
Joined
·
58 Posts
Discussion Starter #4
Thanks for the help..

Ive took the bsi out and found signs of water corrosion so ive cleaned it up and resoldered what looked to be corroded..

but still have the same problems..

im just doing a bsi reset now, so any further help would be appreceated.

ASH
 
1 - 5 of 5 Posts
Top