Peugeot Forums banner

1 - 12 of 12 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hi everyone,having a nightmare with my van hard to start and when it is running it feels flat and not running to full potential and when under hard acceleration it cuts out,if i turn ignition off and on again it can be bumped whilst still moving but if i stop it might start or it might take 5 minutes to start,i think it may be the crank sensor but dont know where it is,must be at the back of the gearbox
any help appreciated thanks
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
yes going to but just wanted to check the connection and state of it whilst i wait for lexia to turn up
thanks
 
D

·
Guest
Joined
·
0 Posts
Crank sensor is fitted to the top of the bellhousing. Easy enough to get at.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #6
fault codes

having read the fault codes there were loads,but the only one relating to engine was something like,
high pressure fuel system pressure too low check for leaks
there are no leaks so i m guessing pressure regulator is gone is this correct or am i barking up the wrong tree

thanks
Andy
 

·
Registered
Joined
·
38 Posts
hi
had this problem before. have a leak back test done on your injectors,when the engine is under load if you have an injector that has a high leak back it will drop the fuel pressure and cut out.
 
1 - 12 of 12 Posts
Top