Peugeot Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Dear all,

I am attempting to install a gadget into my Peugeot 308. However, it needs to be joining the brake & horn wiring of the vehicle.

I am hereby seek advise on which wire is belong to the horn as well as the brake. In addition, where is the best location of the wiring to be connected of the external wiring.

Thanks in advance.
 

·
Moderator
Joined
·
11,731 Posts
For brake I'd probably say the brake switch light, its usually in the passenger footwell on a long bar that runs the width of the car.
 

·
Moderator
Joined
·
11,731 Posts
Either in the wiring loom behind the wheel or anywhere from where the horn wires come into the bulkhead, assuming you can find them. Horn is usually behind the passenger side wheel arch liner.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
Either in the wiring loom behind the wheel or anywhere from where the horn wires come into the bulkhead, assuming you can find them. Horn is usually behind the passenger side wheel arch liner.
It would be great should the exact location pointed out......:thumb:

Would it be possible to access the wires which connected at the steering wheel?
 

·
Registered
Joined
·
5 Posts
Discussion Starter #6
It would be great should the exact location pointed out......:thumb:

Would it be possible to access the wires which connected at the steering wheel?
This might be the info which I am looking at. However, just can't understand with its languages. Does any experts here mind to translate?

Pls click below:-
[StarLine]
 
1 - 7 of 7 Posts
Top