Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Hi, I recently got myself another peugeot which is the 307sw with 1.6 16v under the bonnet. I was happy with the car for the first few weeks until the "Check engine" light came on, I have connected my diagnostic computer and got an error p0341 - Camshaft position sensor issue. I went ahead and got a new replacement sensor, fitted and no change so I went and got a lend of 100% good sensor from a mates car and still no change... At this point I didnt know what to do so went onto Autodata and did a bit of research on the harness and started to check it. I noticed there were cables added to extend the cable that is going to the sensor so got rid of them and did a straight cable from the sensor to the ecu but that didnt do any help. Did anyone have a problem similar to mine ?
 

·
Registered
Joined
·
61 Posts
Hi, are you sure that's the fault code number you got? P0431 comes up as warm up catalyst efficiency below threshold Bank 2 in my data book.
 
1 - 6 of 6 Posts
Top