Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Hi all parking sensor fault on dash
1 where is parking sensor ecu located?
2 do I have to remove bumper to get to parking sensors? Or is there a shortcut removing the black insert trim? Can this be done?
3 worst case scenario can I turn off this option completely within bsi on planet?

Thanks justin
 

·
Registered
Joined
·
687 Posts
Senors can be reached from underneath. It's probably worth giving the connectors a good clean and a spray in something protective. Mine play up from time to time, but a good clean and respray resolves the issue

The ECU should be located in the boot on the LHS under the side trim. You'll be able to tell if it is there by following the senor loom underneath and it will be above the grommit that the loom uses to enter the inside of the car.
 

·
Registered
Joined
·
3 Posts
Had a faulty sensor myself before and if you can get down close enough by putting your ear against each sensor you should hear a clicking noise coming from it if it broken
 

·
Registered
Joined
·
1,825 Posts
If you do a global test with PP or Diagbox it will tell you which sensor is faulty.
 
1 - 4 of 4 Posts
Top