Peugeot Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Sorry, bit of a newbie with forums and Peugeots, I have owned a 307 D Turbo HDi, 2003, for about 6 months, keep getting an anti pollution fault come up it then goes into limp mode, this eventually clears but comes back a week or so later.

Whilst the car was in for an MOT at a local garage (not main dealer) I mentioned this to the mechanic, who said he will do a diagnostics check, this is what it threw up!

P0100 - Flow sensor signal air flow measured abnormally high, mass air flow sensor malfunction

P1442, P1537, P1448, P1447 & P1429, but the mechanic didn't seem to know what these meant.

Does anyone know what is wrong with car? how serious is it? and more importantly how expensive could it be?

Starting to panic, so any assistance would be much appreciated.

Many thanks
 

·
Registered
Joined
·
9,731 Posts
graystep said:
Sorry, bit of a newbie with forums and Peugeots, I have owned a 307 D Turbo HDi, 2003, for about 6 months, keep getting an anti pollution fault come up it then goes into limp mode, this eventually clears but comes back a week or so later.

Whilst the car was in for an MOT at a local garage (not main dealer) I mentioned this to the mechanic, who said he will do a diagnostics check, this is what it threw up!

P0100 - Flow sensor signal air flow measured abnormally high, mass air flow sensor malfunction

P1442, P1537, P1448, P1447 & P1429, but the mechanic didn't seem to know what these meant.

Does anyone know what is wrong with car? how serious is it? and more importantly how expensive could it be?

Starting to panic, so any assistance would be much appreciated.

Many thanks
Heres your codes to start with -

P0100 Generic Mass or Volume Air Flow Circuit

P1442 Evaporative emission control system Leak detected
EDC15C2-Quantity of additive Additive ECU.

P1537 Intake manifold runner control (Bank 1) Stuck open
EDC15C2 - Accelerator pedal jammed. Strategy activated.


P1448 ELC system 2 fault
EDC15C2 PEF: Particulate emission filter overloaded.

P1447 ELC system closure valve Flow fault
EDC15C2 - PEF filter pierced or differential pressure incorrect. / PEF: Particle emission filter. Clogged particle filter.

P1429 Electric air pump Primary failure
EDC15C2 Particulate Differential pressure sensor value. Coherence of the differential pressure when stopped.
 
G

·
Well for a start it sounds like new maf sensor, new particulate filter or a cleaning of it and a top up and reset of the eolys/additive system

However i may not be 100% there, cant learn these things probperly till my planet arrives :mad:
 
1 - 3 of 3 Posts
Top