i have a 307 with two keys one with a plip one without my question is if i get a second hand plip off ebay (same board number PN. 73373067B) can it be reprogrammed to the car? thanks all in advance
Were is the FAP/DPF sensor 307 2,0 HDI 2002 RHS engine. I have change the partikel filter but even that i get a fault that says filter full so i whant try to change the sensor. If you have some picture also post them please. Get also a fault Pre/Post heating relay circuit. Blocked relay.
Hi,Could anyone tell me where the Manifold Pressure Sensor is.
307 COUPE CABRIOLET - 2 DOOR 2.0 i 16v 138 4-SPEED AUTOMATIC GEARBOX Petrol
PRODUCT TYPE
CAR
COMMERCIAL MARQUE/COMPONENT TYPE
PEUGEOT
VEHICLE FAMILY
307
SILHOUETTE
COUPE CABRIOLET - 2 DOOR
TRIM LEVEL
DYNAMIC
ENGINE...
Hello guys, i have one question about my car. I think the dual-mass flywheel is near the end because i feel vibration in car when i start on and off. But first time when i feel that is today after my repairman put the new engine block carrier. ( I hope is just maybe that incorrect ) But in worst...
I've a 2002 307 1.4 diesel driving in heavy rain and deep puddles car was fine but then just cut out and now turns over but won't start have a feeling its a sensor that has got wet and is shorting out can anyone suggest where to look or what else might be good to test thanks
Hi All,
I have a mis fire and Mil on in my sons 2005 1.4 petrol 307. Code reader gives PO352 28 ignition coil fault. Clear the codes and replaced with good set of plugs and ignition pack from my other sons 307 car and the fault and symptoms and code re appear. Put lugs andpack back into the...
A forum community dedicated for all Peugeot owners and enthusiasts. Come join the discussion about performance, reviews, reliability, modifications, troubleshooting, maintenance, for all models.