Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi new to all this forum malarkey..

I recently purchased a rather spiffing 307 HDi (2002) 2.0 peugeot but it has started beeping at me claiming anti-pollution and the engine management light is on. :(

It drives ok ish, is a bit sluggish so Im guessing its in limp mode?

It over runs slightly when you turn the engine off and has conked out a couple of times (basically faded out) but re-starts if you wait a couple of minutes.

Local garage have aparently had it on the diagnostic machine, cleared the computer system but after a couple of days it comes back on again.:eek:

Read lots of horror stories about peugeot not being able to diagnose the problem correctly, it being a common fault blah blah blah?

Any ideas would be appreciated, might wizz it into local peugeot and see what they say (Norfolk)
 

·
Registered
Joined
·
9,733 Posts
diagnostic test threw out following codes:

p1138 & p1112
P1138 High pressure rail sensor fault / Lack of HO2S 2 switching - Sensor indicates rich
EDC15C2 - Fuel pressure. Stop requested but regulator still active

P1112 Intake air temperature (IAT) sensor circuit Intermittent low voltage
EDC15C2 - Diesel high pressure monitoring function. Pressure lower than the minimum pressure. (leak).
MM4MP2 - Motorised throttle control.
 
1 - 3 of 3 Posts
Top