Peugeot Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·

I'm new here so please forgive me if I've posted in the wrong bit.

Basically, I've brought myself an auto dimming mirror from eBay to fit to my Peugeot 207. It has the rain/light sensor so I have the connector there for it. However, upon disassemble after it not working, the person that has sold it to me has managed to rip the wires out of the connector on the PCB behind the mirror.

I have found three wires, brown, yellow and black/white. There is a white connector block with 7 pin slots on the PCB. One is marked IGN (I assume that'd be the brown wire). The pin on the left is marked 1. I haven't a clue where the rest of the wires would go. I have attached a picture of what I have to help.

If anybody knows which pins these wires go in the connector, or can point me in the right direction for some help, it'd be much appreciated. I'd much rather repair the unit if I can, probably can't send it back now I've prized it apart!

Many thanks, Sam


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.