Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Good afternoon all, I'm new to the forum and wondered if anyone had fitted a Temperature Sensor to a VTI engine?. I've bought the part (which looks to be a push in type) model 1338F3 and could use some advice on how to fit. I'm told it can be done without drawing the system.. please help ?
 

·
Registered
Joined
·
17 Posts
Yes, it can be replaced without draining the whole system, but it will always leak some.
make sure to put some grease on the rubber when you install it, and Prefferbly when the engine is cold to avoid the risk of getting burned. Keep the Expension tank closed when completing it, this will help to reduce the drain significantly. After you installed it, refill and bleed the system.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3
Hi thanks. Did it this morning before I saw your post ? no leaks as yet... engine revs sitting too low so car is stalling.. this normal?
 
1 - 3 of 3 Posts
Top