[CallMeFoxie]

Did you manage to reset adapations? Not sure if there's any regarding fueling though. If the engine was running hard maybe it needed more fuel before the rebuild? Cannot explain it any other way

 

[CallMeFoxie]

I had P0011 last week as well, however I have been having troubles with cold drives where it struggled around 2500 - 2800 RPM and on the first rev to these RPMs it would completely cut fuel for 5 seconds, also it would idle at 900 RPM instead of 800 RPM. If I restarted with the engine hot it would work fine.

I got a new VTi solenoid (from ERA, cost 50 pounds) and took the old one out - it was filled with all kinds of junk (the engine has 13 years and almost 120k miles, from which 45k has been done over the past 3 years driving across europe). So far it seems to actually be fixed, done two routes (about 150km in total) and it has not re-appeared.

 

[CallMeFoxie]

I tracked it in this thread Engine performance lower when starting cold or even... (read from the top if the symptoms sound familiar)