Peugeot Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi, I am fitting a set of reversing sensors to my Peugeot Partner Van (15 Plate). The simple stuff has gone fine and I have run all the cables to a little cubby hole on the left hand side behind the rear light cluster.

The next step, I believe, is connecting the power cable from the sensor unit. I have a red and black wire and think one should go to an earth and the other to the reverse light feed wire.

So now im stuck!! Which one of the red and black goes where and which of the 6 available cables into the cluster is the reverse one (picture below)??

Thank you for even reading this. All help, tips and advice appreciated.
88265
 

·
Registered
Joined
·
1 Posts
it is the brown wire on switch the right-hand side light unit , left hand side wiring is different to right. got mine sorted today 14/07/2020 hope this helps.
 
1 - 2 of 2 Posts
Top