Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
Any clues please my on board computer has stopped working all that is working now is the clock,radio,temperature.Cheers.
 

·
Moderator
Joined
·
5,886 Posts
If the temp outside drops below 3 degrees the trip computer switches to outside temp as a warning you can cycle through display modes with button on end of wiper stalk.
 

·
Moderator
Joined
·
5,886 Posts
Could be a sticky stalk button. If you have access to planet you could check operation and if any faults are listed. You could always try a BSI reset as that may reset the trip computer if it has thrown a wobbly:)
 

·
Moderator
Joined
·
5,886 Posts
BSI Reset Procedure

Put the driver's window down, lift the bonnet and ensure all equipment is switched off.

Ensure all doors are closed and remove key from the ignition.

Wait for at least 3 minutes, disconnect the vehicle battery and wait 15 seconds.

Reconnect the vehicle battery, wait a further 10 seconds (do not open doors.).

Switch on the side lights through the driver's window.

Switch on the ignition and check system's functionality.

Start the engine and complete the system's check.



If remote fobs stop working

Turn on ign

Hold lock button on key down for 10 seconds.

Remove key open & close door test central locking system.
 
1 - 6 of 6 Posts
Top