Peugeot Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Hi,
I would be very grateful for some help. Recently bought pp2000 and interface from eBay. After fun and games getting the software activated using keygen ....was finally ready to read the fault codes on my 307 ....or so I thought :mad: When connected to the car I cannot open 'Peugeot Planet Diag ' I get this error message "Error. Impossible to launch the application: Try again or try another application" It is obviously not the full software .....is the 'diag' software available and would it 'intergrate' into the activated PP2000 that is already on my laptop.

Please, any help or advice would be extremely appreciated :thumb:

Kind Regards David
 
J

·
Guest
Joined
·
0 Posts
If you think you have problematic software, download it from Phil's site... Directory list as this one works perfectly.... I used it, and no problems :thumb:

Edit: just re-reading your post.... don't try opening Peugeot Planet Diag.... open Peugeot Planet 2000.... second one down on the list :thumb:
 

·
Registered
Joined
·
580 Posts
Hi,
I would be very grateful for some help. Recently bought pp2000 and interface from eBay. After fun and games getting the software activated using keygen ....was finally ready to read the fault codes on my 307 ....or so I thought :mad: When connected to the car I cannot open 'Peugeot Planet Diag ' I get this error message "Error. Impossible to launch the application: Try again or try another application" It is obviously not the full software .....is the 'diag' software available and would it 'intergrate' into the activated PP2000 that is already on my laptop.

Please, any help or advice would be extremely appreciated :thumb:

Kind Regards David
NOT QUICK ENOUGH

I think you just need to open Planet 2000 application to interrogate the ECU's to read the faults.
Someone else will confirm.
There is a link to a user guide on here somewhere, I'll see if I can find it.

Here is a link to a user guide
Malcolm.
 

·
Registered
Joined
·
495 Posts
You need to select the second option down pp2000...Peugeot Planet Diag will not work.
Select pp2000 then select "ecu configuration" "global test" this will scan all your cars ecu's and state if there are "faults present" or "no faults found"

e.g. select engine ecu and then you can read faults/clear faults/parameter measurments etc....read faults and report back here with the p codes.

To find the p code for each fault select the (!) button on the bottom of the screen..once all fault code are recorded then clear faults and see what faults comes up fresh...:)
Keep out of the configuration sections until you get used to planet...:thumb:
 

·
Registered
Joined
·
6 Posts
Discussion Starter #5
Excellent stuff guys (jmkent, malcolm and risky 1) :thumb::thumb:

Thank you , will 'hook-up' tomorrow and see what happens :cool:

All the best
David
 

·
Registered
Joined
·
6 Posts
Discussion Starter #6
Hooray :thumb: finally got into global test and checked engine ECU.....now the bad news

Three error codes (307 diesel 2.0 )


P1198 Permanent fault, diesel high pressure monitoring, flow regulator at stop.

P0336 Intermittent fault, engine speed signal coherence

P0402 Intermittent fault EGR circuit, airflow measured higher than recommended

I am hoping that P0336 (crank shaft sensor ??) and the EGR fault are causing the diesel pump error .....or is that wishful thinking :eek:

Any advice Gentlemen :)

Kind Regards David
 
1 - 6 of 6 Posts
Top