Peugeot Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi everyone I am new to here I need info if possible have a 04 peugeot partner
1.9d bsi replaced with new unit due to water ingress.problem the battery was flat so I charged up fully,but shows eco mode will that stop comms with diagnostics I plug in pp 2000 but there is no dialogue with any module showing
In Diagbox including the new bsi is this normal .Also what does the other electronic module do the one in the fuse box under the bonnet please.
Thanks .:thumb:
.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #4
Hi it's a new one fitted by customer don't know if it's configured yet as I have no dialogue with any module yet is this because it's in eco mode or can I still configure bsi help.:cool:
 

·
Registered
Joined
·
9 Posts
Discussion Starter #5
Hi thanks for prompt prompt reply mate I have the old bsi unit when I read 95160
I noticed vin number is missing from dump.Also do you know what the the purpose of the other electronic unit 9643498980-80 fuse box under bonnet by n/s headlamp.
Thanks.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #6
Hi David it's a new bsi already fitted to van it's a none runner at the moment mate any help will be grateful I have the old bsi but I suspect it's corrupted as there is no vin number showing in dump ?.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #8
Hi David looked at it this morning more closely it is configured mileage gauges work beeps when you open door with him key still in.where is the pump module situated
Fuse 18 has no power because eco mode? .Tried to follow on autodata circuit but it's not
correct .
 

·
Registered
Joined
·
9 Posts
Discussion Starter #9
Hi still stuck in eco mode I believe that is why I have no dialogue with any module yet can anybody tell me where pump module is please
 

·
Registered
Joined
·
9 Posts
Discussion Starter #10
update no dialogue with any modules

Hi david managed to get access with pp2000 now, did a global test found no faults with any modules, including ecu, bsi ect apart from intermittant fault comms to intrument panel and that is clear now. Still no start tried testing
operation of egr,glow plug heater,advance unit in pump all operating using pp2000 all appear to be working by sound, But i cannot find any test for fuel shut off solanide on pump (how to test? ).
I am now going to check glow plugs and crack open the injector pipes to see if any fuel ? i did notice that even with a fully charged battery does not appear to crank as fast as i would expect it to possible starter motor anything else
i can try :nono:
 

·
Registered
Joined
·
15,377 Posts
Its a 1.9 not an hdi so no way of checking fuel pressure in planet :)

Eco mode irrelevant should still get comms and will start if its able to even in eco mode

Was the van running on old bsi before change if not bsi might not have been the real problem
 
1 - 15 of 15 Posts
Top