Peugeot Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
hi all again !!!!!!!!!

just tried the bsi reset x2 but the car did not beep when i switched it to side lights ! ? i waited the full 3 mins etc and followed it step by step

any ideas ?? ? :eek:
 

·
Registered
Joined
·
62 Posts
Discussion Starter #7
spoke to you earlier today the 2004 plate 307 hdi ! white smoke when start in morning and takes a few cranks to start it !?? do you think its a crank sensor ? :thumb:
 
D

·
Guest
Joined
·
0 Posts
Oh yes.
Any a BSI reset has nothing to do with engine management problems.
Could be a crank sensor yes.
The sensor would need to be put on an oscilliscope to diagnose it correctly, especially if it is an intermittant problem. It could be breaking down with temperature etc.
 
D

·
Guest
Joined
·
0 Posts
On the very top of the gearbox.
Its unlikely to be the problem.
Most likely its a fuel pressure problem, the minimum pressure is not being built on cranking.
 

·
Registered
Joined
·
62 Posts
Discussion Starter #11
thanks can i see it from the top of engine> and change it or is it under the car job ? ! so what would you say to me to look for then if its not the sensor ? really hope its not going to be a expensive job to repair !? :D:eek:
 
1 - 11 of 11 Posts
Top