Peugeot Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
204 Posts
Discussion Starter #1
I purchased a new fob case, it was the same as mine but with a different key.
I put my pcb in the new one, as well as my blade. The blade was a tight fit, but I got it in. It unlocked the car perfectly, but when trying to start it just turns over and there's nothing.

Now, the blade I have is this one:



But the new fob came with this blade,



My blade is a much tighter fit in the new fob.
Have I missed something? I was very quick in changing the battery.
Does the blade have to touch the PCB?

Any help appreciated :eek:
 
C

·
Guest
Joined
·
0 Posts
Have you tried coding it with planet, may have lost it when being swapped over.
 
C

·
Guest
Joined
·
0 Posts
It's worth a try it ain't gonna cost you anything, only other thing I can think of is the transponder wasn't on the pcb and is either in old fob or lost but afaik the transponder is on the pcb.:confused:
 

·
Registered
Joined
·
437 Posts
If you have the original 307 (pre face lift) then the transponder chip is separate to the PCB.

Did you transfer the chip into the new case?
 

·
Registered
Joined
·
204 Posts
Discussion Starter #7
It's worth a try it ain't gonna cost you anything, only other thing I can think of is the transponder wasn't on the pcb and is either in old fob or lost but afaik the transponder is on the pcb.:confused:
This!

I never even thought of taking the old one out. It just slipped my mind. All good now, thanks! :thumb:
 
P

·
Guest
Joined
·
0 Posts
This!

I never even thought of taking the old one out. It just slipped my mind. All good now, thanks! :thumb:
Done same thing on my 306, makes you feel a right twonk after. BTW where did you get the new key?
 

·
Registered
Joined
·
204 Posts
Discussion Starter #12
1 - 13 of 13 Posts
Top