Hi could someone who has done there own clutch tell me how hard it is to do.I will be doing it on my drive so its going to be hard i no.Is there any star bolts and stuff like this as i no peugeot like to use them in strange places.Thanks.Is it worth trying to do your self or just pay a garage to fit it.I been quoted about 350 from them??????????????
new clutch
Join the discussion
Recommended Reading
-
307 won't start
307I've a 2002 307 1.4 diesel driving in heavy rain and deep puddles car was fine but then just cut out and now turns over but won't start have a feeling its a sensor that has got wet and is shorting out can anyone suggest where to look or what else might be good to test thanks- 2
- 73
-
Misfire on 307 1.4 petrol.
307Hi All, I have a mis fire and Mil on in my sons 2005 1.4 petrol 307. Code reader gives PO352 28 ignition coil fault. Clear the codes and replaced with good set of plugs and ignition pack from my other sons 307 car and the fault and symptoms and code re appear. Put lugs andpack back into the...- 7
- 142
-
2002 Peugeot 307 2.0L MAP sensor problems
307Hi there, i have a 2002 Peugeot 307 2.0L thats giving me a P0106 fault code, the engine doesnt idle, blows black smoke, backfires etc etc, i have replaced the MAP sensor with no change to engine performance, have then gone a little deeper to check power to the MAP sensor, i have a 5v signal wire...- 5
- 132
-
peugeot 307
307Hi Can any one help i have Peugeot 307 i have replace all brakes and disk pads i new A.B.S SENSOR and am still have like a grinding noise sound like its coming from front left side of car any ideas. stump- 3
- 93
-
stump7777 · updated
-
Oil dipstick
307Hi, I have changed 4 dipsticks in my 1.6 HDi 2005.I pull it out as gentle as i can,but after two times plastic snaps and stays down. In Peugeot Citroen store they told me that they dont have any other solution-just be carefull?! Also asked my mechanic,he said i hate to pull it out-let it stay...- 6
- 107
-
Biba · updated
Join now to ask and comment!