Peugeot Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
hi every 1 just after a bit of information iam running a 106 1.5d and iam wanting to do a dturbo conversion just wondering what bits i will need i have had a few redtop corsas and are not really hard to build i was wondering by comparison how hard or easy it is to convert my 106 i no i will need engine box wiring harness struts hubs shafts and also were i would get engine mounts from or will i have to have them made thanks every1
 
G

·
The first thing you need to buy is a tape measure - the XuD is a tight squeeze between the turrets in a 405s engine bay, which is actually smaller than a 306s, but both are enormous compared to the 106s.

That said, if (and that's a big 'if') it does fit then it'd make a brilliant laugh-of-car.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top