Peugeot Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have an Antioplution Fault on my 307 1.6hdi estate (2005). It runs OK until I accelerate hard, then the car either goes into 'limp' mode or the engine stalls altogether. I have also noticed an exhaust smell in the car when standing in traffic or moving slowly. I checked the injectors and found that the seal on the third injector is leaking. I have booked it into the garage to have the seal replaced. Could the two issues - the antipolution fault (limp mode, stalling) and the leaky injector seal be related?? Would be nice if they are!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top