Peugeot Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have just replaced the head gasket on wifey 206cc. I pinned the cams but could not pin the crankshaft as the hole had been blanked off. I thought nothing of it and without thinking did not mark timing marks on crankshaft.
After reassembling I find that I can't rotate the crankshaft as after one rotation the crankshaft jams. I have tried finding tdc number one cylinder with the timing belt off and the cams pinned but the cams are springing back jamming the locking pins.
I am sure that this is a case of a little knowledge being dangerous because I am not sure where to turn to from here.
Any advice appreciated
 
1 - 4 of 4 Posts
Top