Peugeot Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1 (Edited)
Hi my friends.
I just recived my diagbox end managed 2 update to 7.02.
There is a updater on the cd to make the 7.02 a 7.04
But it needs a code.
Alsow for driver installation i need a code.
Can sombody please help me 2 update 2 latest version.

Ok i found the code end 7.04 is installed.
How to upgrade to latest ?
Do i need en how to flash interface?
 

·
Registered
Joined
·
1,947 Posts
You're in the same boat as me. Except I'm still on the version I bought my interface with about 49 years ago. Every time I try and update it, it fails. So I'm stuck with a newer car and unable to do full scans. Plus I'm getting errors every 2 minutes.
 

·
Registered
Joined
·
24 Posts
Hi my friends.
I just recived my diagbox end managed 2 update to 7.02.
There is a updater on the cd to make the 7.02 a 7.04
But it needs a code.
Alsow for driver installation i need a code.
Can sombody please help me 2 update 2 latest version.

Ok i found the code end 7.04 is installed.
How to upgrade to latest ?
Do i need en how to flash interface?
Who did you buy the tool off?
 

·
Registered
Joined
·
73 Posts
I am in the same place as well.

Installed Diagbox 7.01 last night, activated it up to 7.02

Then tried upgrading to 7.04 through to 7.16 but the activation is killed.
My instructions say to manually activate after each upgrade, but that option has gone, but it was there in the first install.

Just started with 7.01 again to make sure I didn't miss something.

My cable is an international one I used with my Citroen Lexia in a previous life so I know that's ok.
 
1 - 4 of 4 Posts
Top