Peugeot Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Hi all

I spotted this in PP before, but now cannot find it!! Can anybody describe how to reach it again please?

Currently got file cap open light and climate control blowing boiling hot then freezing cold in a constant cycle.

Thanks, Nik
 

·
Registered
Joined
·
1,424 Posts
Not sure about BSI reset within planet but this works for me


1. Disconnect the diagnostic tool.
2. Put the driver’s window down, lift the bonnet and ensure all
equipment is switched off.
3. Ensure all doors are closed and remove key from the
ignition.
4. Wait for 3 minutes, disconnect the vehicle battery and wait
15 seconds.
5. Reconnect the vehicle battery, wait a further 10 seconds (do
not open doors.)
6. Switch on the side lights through the driver's window.
7. Switch on the ignition and check system’s functionality.
8. Hold lock button on key down for 10 seconds.
9.remove key open & close door test central locking system
10. Start the engine and complete the system’s check.
Failure to follow this procedure could result in incorrect operation of many
BSI related items.
It did take three attempts following this procedure before it worked.

hope this helps :)
 

·
Registered
Joined
·
15,377 Posts
AC blowing hot and cold is probably gas pressure low or faulty relay in BSI not sure you can reboot BSI in planet maybe you were looking in configuration somewhere
 
1 - 3 of 3 Posts
Top