Peugeot Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
399 Posts
Discussion Starter #1

Attachments

·
Moderator
Joined
·
11,873 Posts
That keygen you used was very different to the one I used. Glad it got sorted though.

How's the fan? I have a feeling you may need to do some work in that area.
 

·
Registered
Joined
·
399 Posts
Discussion Starter #13
That keygen you used was very different to the one I used. Glad it got sorted though.

How's the fan? I have a feeling you may need to do some work in that area.
The fan setting got changed not your fault I just seen it saying something different than 3 4 stage (Or something like that can't remember)
Set it back to original then all fine :thumb:
Thanks for your help mate:thumb:
 

·
Moderator
Joined
·
11,873 Posts
Ah, good stuff. I've known two 307s with fan issues which occur after repeated starts in close succession.

It was down to bad connections on the relays under the front grille.

Once they were stripped and cleaned they were all fine. As your's is in a similar age gap it might be worth you checking them out.

You can't get the whole of the front grille off because of the bumper, but you can get it open just enough to get your hand in to get to and clean the relay connections.
 

·
Registered
Joined
·
2 Posts
Diagbox and pp2000

Pug 207 57reg

Hi, I have recently bought a Lexia 3 and am also having trouble with PP2000.
I installed Diagbox from DVD labeled PP2000 V47 / DiagBox 6.01 which seemed to install OK, using a supplied printed guide.
The Global test works, but PP2000 says USB not connected or being used by something else.
Reading other posts about PP2000 wanting a genkey, do I need one?
If I do how do I input it, as it is not stand alone.

Thanks for reading.
 
1 - 15 of 15 Posts
Top